Abstract
Blades may be considered to be the heart of turbine without blade there would be no power and the slightest fault in blade would mean a reduction in efficiency and costly repairs. The centrifugal force is one of the problems faced by the designer of blades especially at the first stages. The designer aims at reducing the stresses with in the allowed limit. The ANSYS 15 software was used as far as it is the most effective in analyzing the different numerous cases of stresses, the blades with limited root in all direction (X,Y,Z) were taken into consideration . The centrifugal forces were applied on the rotor blades at running speed of 6000 r.p.m., The finite element models of the blade were constructed using D3-10-noded Tetrahedron elements shape, SOLID 187, mesh of the entire blade 23406 Node,136575element. The average of normal stress, Von misses, Maximum principle stress, Minimum principle stress were calculated according to ANSYS 15 program, these stresses are as the result of the effect of centrifugal force for all planes along the blades and then values of stresses were compared to the curves for each alloy.The current research concluded that the Titanium alloy is the best alloy used in terms of reducing stresses due to centrifugal force, that is because density of Titanium alloy used is less than that of other used alloys, leading a reduction in centrifugal forcess that are directly proportional to mass.
